How should I connect the remote wire so that I don't have to disconnect it when I turn off the car? Should I tap into wires that input into the bose amp or the output wires and which colors. Anything I add must be tied in post factory amp. There is only front and rear speaker input but the amp also supplies a woofer? Getting this wrong may well overheat cables or even blow the amp itself so make sure your cables and setup are matched. To check the frequency response and make sure they are playing full range and not crossed over, you can play a frequency sweep through the front speakers, then the rear and measure the response.
This article has also been viewedtimes. Dull sounding. Avoid running subwoofers at any impedance the manual does not list. Step 3 Connect your amplifier or powered sub to your car's stock head unit. Terrific work!
The lower the impedance, the higher the wattage output, but this has its limits.
Adding RCAs to a Standard Car Head Unit
Reply 5 years ago on Introduction. A single 4-Ohm coil subwoofer is driven at 4-Ohms at all times. For example, a dual 4-Ohm subwoofer can be wired to 2- 4- or 8-Ohms. Do you realize what the power capacitor does in a car stereo system? This can be pretty frustrating as it means your subwoofer level may stay the same regardless of you turning up the volume knob on the stereo. Then unplug everything, put it all back in your dash and plug it all back together again If it doesn't work, make sure you have tested the connections with a multimeter and redo any that fail Also, my converter has "Gain adjusters" on the PCB you can adjust with a screwdriver, be sure they aren't turned all the way down, i'm sure they don't go all the way to 0 signal but it's best to be sure:
How to hook up an amp and sub to a stock stereo.
Or do you prefer I try to purchase maybe a more up to date amp for my optimal set up. If you bought a kit it comes with an inline fuse, if you didn't, you need to get an inline fuse. Hi Daniel! I have an 07 maxima with a Bose amplifier. Easy Modular Magnetic Desk Lamp. But you can tune the Front and Rear channels separately on the amp to get a balanced sound that is appealing to you. One way to check this is try fading just to those speakers, than balance it left and right.